The three-dimensional configuration of the ester heterocycle is basically the same as that of the carbocycle. Compound: Aluminum(III) sulfate xhydrate(SMILESS: O=S(O)(O)=O.O=S(O)(O)=O.O=S(O)(O)=O.[H]O[H].[Al].[Al],cas:17927-65-0) is researched.Formula: C5H7N3S. The article 《Application of high rate ballasted flocculation technology in wet weather flow treatment》 in relation to this compound, is published in WEFTEC ’99, Annual Conference & Exposition, 72nd, New Orleans, Oct. 9-13, 1999. Let’s take a look at the latest research on this compound (cas:17927-65-0).
An innovative treatment technol. to address wet weather events is the ballasted flocculation process (e.g. Actiflo/Microsep from USFilter). The principal benefits of a ballasted flocculation treatment system for wet weather flows include vastly reduced space requirements, rapid start-up and response times, relative insensitivity to fluctuations in raw water quality, and removal rates greater than conventional systems. The key behind the ballasted flocculation process is the use of continuously recycled ballast or fine sand, which attaches to a flocculated particle through a polymer bridge. The addition of ballast provides 2 benefits: the high sp. gr. sand weights flocculated particles leading to much faster solids settling, and the increase in collision frequencies between sand and flocculated particles dramatically increases flocculation kinetics, resulting in very short mixing times. With rapid particulate settling and flocculation kinetics in ballasted flocculation systems, process design must focus on several fundamental parameters within the clarifier to maximize removal efficiencies and minimize plant footprint. This design approach was adopted in pilot testing of the USFilter ballasted flocculation process during wet weather flows at a variety of sites from 1997 through 1999. High quality, consistent effluent characteristics were achieved despite varying influent conditions. High quality effluent was produced within minutes of start-up, ideal for addressing transient wet weather or peaking events. Removal efficiencies through the ballasted flocculation process of over 85% for total suspended solids and over 60% for BOD were demonstrated. Even with a total hydraulic retention time of 6 min, sufficient residence time for mixing and flocculation was available, resulting in a very small footprint approach for wet weather treatment. With high levels of solids removal in a compact footprint, ballasted flocculation provides a cost competitive alternative to conventional clarification and biol. systems for treating wet weather flows.
The article 《Application of high rate ballasted flocculation technology in wet weather flow treatment》 also mentions many details about this compound(17927-65-0)Recommanded Product: 17927-65-0, you can pay attention to it, because details determine success or failure
Reference:
Isothiazole – Wikipedia,
Isothiazole – ScienceDirect.com